TMax 1150 °C (2100 °F)
Furnace available in a variety of standard sizes ( also custom designed) from 25 Kg/Hr upto 800 Kg/Hr with all electric, gas + electric or all gas heating.
Debinding
Chimney Incinerator Muffle
Heating Control
Atmosphere
Separate Debinding and Sintering of Valve Guides
Sintering of Valve Guides
Sintering of Structural Parts
Sintering of Structural Parts
Sintering of Valve Seats
Sinterhardening of Hubs, Sprockets, Gears & Pulleys
Sinter- Braze Hardening of PM CAM with steel tube
The separate process step of conventional heat treament of PM parts can be eliminated in several cases by the process of SINTER HARDENING which is done in a module fitted immediately after the sintering furnace, before the water jacket cooling sections. Furnace atmosphere is recirculated across a heat exchanger and impinged on parts as they emerge from the sintering furnace.
Accelerated Cooling
The length of the water jacketed cooling section can be reduced by the use of an accelerated cooling section placed at the rear of the furnace where the cooling rate is slow.
Automated Material Handling
