• Sintering
• Brazing
• Annealing
• Hardening (air hardenable steels)
• Normalising
• Coatings

High quality consistency is coupled with high productivity in wire mesh belt furnaces that heat and cool parts within protective or reducing atmospheres. Components are characterized by uniform properties and a bright surface finish. Several sizes and designs of furnaces are available, depending on the application, from tiny 50 mm (2 inch) wide belt table tops upto 1200 mm (48 inch) wide belt furnaces which are upto 60 meters (2400 inch) long.

• Electric or gas heated
• With or without muffle
• Direct or radiant tube heating
• Endo, Exo, N₂, H₂, N₂ + H₂ or steam atmosphere
• Alloy steel or ceramic muffles
• Rapid gas quenching module
• Generous zoning
• Auto loading & unloading
• Prewash option
• Post processing oil dip option
• Auto weigh in discharge
• Atmosphere recirculation
• Multipoint atmosphere injection
• Atmosphere analyser & control
• Waste heat recovery
• PLC + HMI control with SCADA programming
• Level II SCADA software control
• Hump back or straight through
• Special designs for tall parts
• Atmosphere zoning
• Muffle supported or roller supported belt

• Sintering of P/M parts
• Fluxless brazing (Iron & SS parts)
  Heat exchangers
  Oil coolers
  Nozzle assemblies
  Pipe assemblies
  Tungsten contacts
  Electrical switchgear
  
• Annealing
  Pressed parts
  Cold & warm forgings
  Cupro nickel coin blanks
  Soft magnetic materials
  
• Hardening of steel parts
  Knifes
  Surgical parts
  Needles
  Watch parts
  
• Normalising of forgings